3/9/2023 0 Comments Ultimaker cura z offsetYou’ve now verified that the Creality Ender 3 S1 is working! Next, we’ll level the print bed and try a test print. Once selected, watch the temperatures of both the nozzle and the bed to ensure they reach the set point and maintain their temperature. You can do this quickly using Prepare > Preheat PLA. If you had any problems, auto-home the printer again after resolving the issue to make sure everything is working properly.įinally, test that the heat bed and nozzle are working correctly by heating both. Check that the end stop for the problem axis is plugged in securely. If you hear grinding from any axis, note the source of the sound, then turn the printer off. If you notice that any of the axes don’t move, check that the corresponding motor cable is completely plugged in. (rotate the wheel to select options in a menu). To home, push the control wheel to access the menu, then select Prepare > Auto Home. Once the screen shows the main menu, the best way to test that all the motors and end-stops are connected is to auto-home the printer, which moves all three axes to their starting points by hitting the end stops, and tests the auto-leveling sensor. If the screen does not show anything, power off the printer, then check for these two common issues:Ĭheck that you set the power supply to the correct mains voltage (115V in USA, see step 6 in the assembly section)Ĭheck that you plugged the LCD cable into the screen (see step 3) Note that the power supply fans will not start spinning until needed. Testing the 3D Printer HardwareĬonnect the included power cable to the power supply and plug it in, then power on the printer using the switch next to the power plug. The Ender 3 S1 is now fully assembled! Next, it’s time to test the printer out and start a print.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |